Cisco 4900M - Catalyst Switch Manual de usuario descargar pdf (Pagina 5)

_____________________________________________________________________________________

Deployment of Dell M6348 Blade Switch with Cisco 4900M Catalyst Switch Page 3

To enable Simple Switch Mode on a Dell PowerConnect M6348 switch, perform the

following steps via Command Line or Web Interface:

Command-Line Interface:

From global config enter the following commands

config# mode simple

config# ip address vlan 4022

config# port-aggregator group 1

config# exit

Later versions of the firmware will not require a reload of the switch, however some

earlier versions do. Reload the switch if requested. You can run the “show run”

command again to verify you are in Simple Mode. This can be seen within the first 5

lines of the running configuration.

look for: !System Operational Mode “Simple”

Web Interface:

Follow the steps below:

• Log into the switch.

• Select System  Operational Mode Operational Mode Configuration.

In the Operational Mode Configuration screen, select

Enable

in the

Simple Mode

drop-

down menu, and left-click

Apply Change

s (Figure 2).

1 2 3 4 5 6 7 8 9 10 ... 34 35

Sin comentarios

Cisco 4900M - Catalyst Switch Manual de usuario Pagina 5