Cisco Catalyst 1800 Guide Manual de usuario descargar pdf (Pagina 4)

2-4 Catalyst 1800 Token Ring Switch User Guide

Special Features

This section explains the following special features of the Cisco Catalyst 1800:

• Using the Display command

• Configuring all ports at once

• Displaying the previous screen

Using the Display Command

Many configuration menus list a Display command among the available options. Use this command

to display the current settings for all ports. If this feature is available for the component you are

using, the system displays a message similar to the following:

Enter port number or 0 for all ports

At this point, you can either type 0 or the port number. If you type 0, the parameters that you change

will affect all of the ports connected to the Cisco Catalyst 1800.

Note Where applicable, Token Ring port configurations will not necessarily affect an FDDI port.

Displaying the Previous Screen

If you want to display the previous screen at any time, press <ESC>.

Accessing the Main Menu

Perform the following steps to access the Cisco Catalyst 1800 Main menu:

Step1 Load your MS-DOS terminal emulation software, such as ProCOMM Plus. (The baud

rate defaults to 9600 bps.)

Step2 Turn on the Cisco Catalyst 1800.

Step3 The Cisco Catalyst 1800 Password menu appears (Figure 2-1). The system displays the

following prompt:

Enter Password

Figure2-2 Cisco Catalyst 1800 Password Menu

Cisco Systems Catalyst 1800 Token Ring Switch

Switch is Password Protected

Password: public

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Cisco Catalyst 1800 Guide Manual de usuario Pagina 4