Cisco Catalyst 8510 MSR Manual de usuario descargar pdf (Pagina 10)

Release Notes for Cisco IOS Release 12.0(10)W5(18b) Feature Packs for the Cisco Catalyst 8510 MSR and LightStream 1010 ATM Switch

78-10701-02

Installation Notes

Step 7 Exit RSL.

Note In the steps above, the Catalyst 8510 MSR and LightStream 1010 configuration register

(config-register 0xnnnn) is not restored.

Note If you press Ctrl-Alt-Delete to quit RSL, the router configuration and the configuration

restore the configuration file, follow the steps above, beginning with Step 2.

Alternatives to RSL

RSL is designed to work with a PC running Microsoft Windows 95 and is the recommended method for

downloading software to the Catalyst 8510 MSR and LightStream 1010; however, you can install the

software using the TFTP process described in the following section.

Note The sample prompts and output shown in the following sections might not be identical to

the prompts displayed on the Catalyst 8510 MSR and LightStream 1010 console.

InstallingtheCatalyst 8510MSRandLightStream 1010SoftwarebyUsingaTFTPServerApplication

Use this TFTP server application method as an alternative method to install the Catalyst 8510 MSR and

LightStream 1010 software from the CD-ROM. You can perform this procedure by using a PC (running

Microsoft Windows 95 or Microsoft Windows 3.1), a Macintosh, or a UNIX system. You can use either

the copy tftp flash or copy rcp flash command to download the software to the Catalyst 8510 MSR and

LightStream 1010.

First, obtain a TFTP application or a remote copy protocol (rcp) application to set up your computer as

a TFTP server or an rcp server. If you are using a PC running Windows 95, you can use RSL or the

TFTP server included on the feature pack CD-ROM to install the Catalyst 8510 MSR and

LightStream 1010 software. For other operating systems, a number of TFTP or rcp applications are

available from independent software vendors, or as shareware on the World Wide Web.

Note To use an rcp application, follow the same procedure below, but substitute “rcp” for

“TFTP”and use the copy rcp flash command instead of the copy tftp flash command.

Step 1 Install any TFTP server application on the PC. (A PC application is included on the feature pack

CD-ROM for Microsoft Windows 95 only.)

Step 2 Start the TFTP server application on the PC by double-clicking the application icon or its .exe

filename.

Step 3 Set up the PC as a TFTP server by using the TFTP server application setup or configuration facility.

Most TFTP server applications include a setup facility that allows you to specify the PC as a server. For

example, from the TFTP menu of one application, select Settings to display a panel. To configure the

local PC as a server, select the Server checkbox.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Cisco Catalyst 8510 MSR Manual de usuario Pagina 10