
7
Release Notes for Cisco IOS Release 12.0(10)W5(18b) Feature Packs for the Cisco Catalyst 8510 MSR and LightStream 1010 ATM Switch
78-10701-02
System Requirements
Substitution of other service categories in shaped VP tunnels (MSRP or FC-PFQ feature cards only)
Dual leaky bucket policing (MSRP or FC-PFQ feature cards only)
Scheduler/Service Class/PVC configuration (MSRP or FC-PFQ feature cards only)
Logical multicast support (up to 254 leaves per output port, per point-to-multipoint VC) (MSRP or
FC-PFQ feature cards only)
Network clocking enhancements for smooth switchover (MSRP or FC-PFQ feature cards only)
Per-VC or per-VP nondisruptive snooping (MSRP or FC-PFQ feature cards only)
Support for non-zero MCR
20
on ABR connections (MSRP or FC-PFQ feature cards only)
Access lists on ILMI registration
CUGs
ATM soft restart
ATM accounting enhancements
CISCO-SYSLOG-MIB support
CISCO-CONFIG-COPY-MIB support
Signaling diagnostics and MIB
Supplemental AToM MIB
Channelized E1 and DS3 Frame Relay Port Adapters
Frame Relay to ATM Interworking Features on the Frame Relay Port Adapters
Hierarchical VP Tunnels
Remote logging for accounting
Tag Switching VC-Merge on Non-UBR VP Tunnels and Hierarchical VP Tunnels
PNNI Complex Node Representation
Support for ATM-Fabric Integration Module in Catalyst 5500
PNNI explicit paths
PNNI alternate link selection
Tag switching CoS
Network Clock Distribution Protocol
Simple Gateway Control Protocol
Inverse Multiplexing over ATM (IMA) groups
ATM End System Address (AESA) gateway
ATM overbooking
Framing overhead
NCDP MIB support
ACL support via ACL daughter card
L3-ATM routing and bridging via RFC 1483 (ATM router module)
21
1. SNMP = Simple Network Management Protocol.
Table 5 Feature Sets Supported by the Catalyst 8510 MSR and LightStream 1010 ATM Switch
(continued)
Feature Set
Comentarios a estos manuales