Cisco Catalyst 8510 MSR Manual de usuario descargar pdf (Pagina 9)

Release Notes for Cisco IOS Release 12.0(10)W5(18b) Feature Packs for the Cisco Catalyst 8510 MSR and LightStream 1010 ATM Switch

78-10701-02

Installation Notes

• During a connection, if the Catalyst 8510 MSR or LightStream 1010 running configuration is not

the same as its startup configuration, the exact configuration is not restored. Any changes that you

made since the last time you entered copy running-config startup-config or write memory

commands are lost.

• RSL restores the Catalyst 8510 MSR and LightStream 1010 startup configuration, but some

running configuration commands are not restored. To restore the exact running configuration,

reboot the router. The following interface configuration commands are not restored to the running

configuration:

–

no shutdown

–

no ringspeed

–

media-type aui

Recovering from a Connection Error

If any of the following elements apply to your installation, modify the Short Timeout value from the

Options dialog box in RSL:

• You are connecting to a Catalyst 8510 MSR and LightStream 1010 that has a large configuration

file.

• You see the following error message:

"Failed to configure the router to enable the Cisco IOS software image and configuration

file upload and download operations. You may want to check the router to make sure that

the selected interface exists."

If you are connecting to any other router or access server, increase the Short Timeout to a value over

25 seconds.

Note If you change the timeout value, you must do so before connecting to the Catalyst 8510

MSR and LightStream 1010 ATM switches, or the new value will not be used. Also,

increasing the Short Timeout value can increase the time it takes for RSL to connect to the

target Catalyst 8510 MSR and LightStream 1010 ATM switches.

Restoring the Startup Configuration

In some cases, RSL is unable to restore the startup configuration. If this happens, follow these steps:

Step 1 Ensure that all cables are properly attached to both the Catalyst 8510 MSR and LightStream 1010 and

the PC.

Step 2 Restart RSL and connect by using the Preconfigured router option.

Step 3 When asked if you want to overwrite the existing startup configuration file, choose no.

Step 4 When asked if you want to continue, choose yes.

Step 5 When the Catalyst 8510 MSR and LightStream 1010 is connected, select Download Router

Configuration in the Router Software Loader dialog box.

Step 6 Select the appropriate file and click the radio button beside Copy configuration to the router

nonvolatile memory. The Catalyst 8510 MSR and LightStream 1010 should now contain the startup

configuration it had before the initial RSL connection.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Cisco Catalyst 8510 MSR Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco Catalyst 8510 MSR