Cisco IAD2431-1T1E1 Guía de instalación descargar pdf (Pagina 19)

To power on the Cisco IAD, follow this procedure:

Step 1 Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.

Step 2 Move the Cisco IAD power switch to the ON position.

The green LED next to the auxiliary port should come on and the fan should operate. If this does not happen, see the

power-on procedure in the Cisco IAD2430 Series Integrated Access Device Hardware Installation Guide.

The following message appears at the end of the boot-up messages:

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]:

Step 3 Enter no to proceed with manual configuration using the command-line interface (CLI):

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]

Step 4 Press Return to terminate autoinstall and continue with manual configuration.

Several messages appear, ending with a line similar to the following:

...

Compiled <

date

> <

time

> by <

person

Step 5 Press Return to bring up the Router> prompt:

...

flashfs[4]: Initialization complete.

Router>

Step 6 Enter privileged EXEC mode:

Router> enable

Router#

Step 7 Continue with the next section, “Performing the Initial Configuration.”

9 Performing the Initial Configuration

This section shows how to prepare the Cisco IAD to perform basic communication functions through its 10/100BASE-T Fast

Ethernet and WAN interfaces.

Note The console port is above the AUX port.

Perform the following initial configuration procedures, as applicable:

• Getting Your Network Information, page 19

• Setting the Fast Ethernet Port IP Address, page 20

• Configuring a T1/E1 Port for a WAN Connection, page 20

• Configuring Digital Voice, page 21

• Verifying and Saving Your Configuration, page 22

Getting Your Network Information

Gather the following information, as applicable, before you begin the configuration process:

• For Fast Ethernet ports: IP address

• For T1/E1 ports: clock source, framing, line code, cable length (T1 only)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sin comentarios

Cisco IAD2431-1T1E1 Guía de instalación Pagina 19