Cisco IAD2431-1T1E1 Guía de instalación Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
22
Verifying and Saving Your Configuration
To verify the configuration and save it in NVRAM so that the configuration remains in effect if the Cisco IAD is restarted, enter
the following commands:
New Syntax for Cisco IAD2430 Series
There have been minor changes to the syntax for Cisco IAD2430 series IADs. These relate to the network-clock-participate
command. Platforms such as the Cisco 3700 series use the following:
network-clock-participate wic
slot#
port
port#
For example:
network-clock-participate wic 1 port 0
The new syntax required by Cisco IAD2430 series IADs is as follows:
network-clock-participate
controller_type slot#
/
port#
For example:
network-clock-participate t1 1/0
network-clock-participate t1 1/1
network-clock-participate e1 1/0
network-clock-participate e1 1/1
Note In addition, the Cisco IAD2430 series default mode setting for the above command is network-clock-participate. For
Cisco 3700 series platforms, the no network-clock-participate command is the default.
Where to Go Next
For additional specialized configuration procedures, refer to the appropriate Cisco IOS software configuration documentation.
Tip See the “User Documentation” section on page 3 for help in locating these documents.
Command Description
Router# show running-config
Displays the current operating configuration, including any changes you
have made.
Router# show startup-config
Displays the configuration currently stored in NVRAM.
Router# show controller t1/e1 1/0
Displays the configuration of the T1/E1 network interface controller.
Router# copy running-config startup-config
Writesthe current runningconfigurationto NVRAM, whereitoverwrites the
startup configuration and becomes the new startup configuration.
Note If you reboot the Cisco IAD or turn off the power before you
complete this step, you lose the configuration.
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios