Cisco ISE - Line Card ISE Manual de usuario descargar pdf (Pagina 38)

Cisco IOS SoftwareConfiguration for theCisco 12000 SeriesOne-Port Channelized OC-12/STM-4(DS1/E1) ISE Line

Configuring the Serial Interfaces

Cisco IOS Release 12.0(27)S1

Step 7 Enter exit to exit configuration mode:

Router(config-if)# exit

Router#

Step 8 Write the new configuration to nonvolatile random access memory (NVRAM) by using the copy

running-config startup-config command:

Router# copy running-config startup-config

[OK]

Router#

Using clear Commands on Serial Interfaces

To reset the hardware logic for a serial interface, use the clear interface serial

slot/port.path:channel-group-number EXEC command, where:

• path depends on the interface configuration (SDH framing with AU-4 or AU-3 AUG mapping, or

SONET framing in ct3 or vt-15 mode; see Table 10).

• channel-group-number is 0 to 30 for an E1 line, or 0 to 23 for a T1 line.

The following example clears serial interface 3/0.1/1/1:1, which is configured in the context of SONET

framing in vt-15 mode. The number sequence .1/1/1/:1 corresponds to the

sts-1-number/vtg-number/t1-line-number:channel-group number sequence.

Router# clear interface serial 3/0.1/1/1:1

Router#

Note As long as the serial interface is available, you can enter this command immediately after

using the enable command to enter privileged EXEC mode.

To initialize the counters for a serial interface, use the clear counters serial

slot/port.path:channel-group-number EXEC command, where:

• path depends on the interface configuration (SDH framing with AU-4 or AU-3 AUG mapping, or

SONET framing in ct3 or vt-15 mode; see Table 10).

• channel-group-number is 0 to 30 for an E1 line, or 0 to 23 for a T1 line.

The following example clears the counters for serial interface 3/0.1/1/1:1, which is configured in the

context of SONET framing in vt-15 mode. The number sequence .1/1/1:1 corresponds to the

sts-1-number/vtg-number/t1-line-number:channel-group-number sequence.

Router# clear counters serial 3/0.1/1/1:1

Clear “show interface” counters on this interface [confirm]

Router#

Note As long as the serial interface is available, you can enter this command immediately after

using the enable command to enter privileged EXEC mode.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 57 58

Sin comentarios

Cisco ISE - Line Card ISE Manual de usuario Pagina 38