Cisco Wide Area Application Engine 612 Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 41
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
110 Chapter 4: Network Integration and Interception
Support for up to 250 virtual partitions, allowing customers to create virtual ACE
modules using a single hardware module
Up to 16,000 real servers, which when used with Cisco WAAS provides nearly infinite
scalability
High availability and scalability by using up to four ACE modules in the same
Catalyst 6500 chassis or across multiple chassis
There are two common deployment models for integrating ACE into the network
infrastructure: bridge mode and routed mode.
In bridge mode, ACE is used to merge two VLANs together. In order for traffic to pass
between the two VLANs, it must pass through the ACE module. As traffic passes through
the ACE module, it is evaluated against the configured service policies to determine whether
or not it should be acted upon. The IP subnet used on the bridged VLAN is the same.
Figure 4-16 shows an ACE module deployed using bridge mode.
Figure 4-16 ACE Deployed Using Bridge Mode
The WAN-facing VLAN in Figure 4-16 is referred to as the client-side VLAN. The VLAN
facing the data center resources is referred to as the server-side VLAN. As traffic enters the
client-side VLAN, it is evaluated against the configured service policy. Traffic matching the
service policy is redirected to a WAE, which has a dedicated VLAN interface configured on
the ACE module. Traffic egressing the WAE comes back into the ACE module, where it is
switched out the server-side VLAN toward the origin server.
In contrast to bridge mode, deploying ACE in routed mode allows for traffic to be routed
between two different IP subnets. Using this deployment model, the client and server-side
VLANs are on different IP subnets. Because the ACE module is a Layer 3 hop, traffic must
be directed to the ACE module through the routing configuration of the hosts or network
infrastructure. Figure 4-17 shows an ACE module deployed using routed mode.
WAN
VLAN 10
10.10.10.0/24
Server Default Gateway
VLAN 20
10.10.10.0/24
Cisco ACE
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41

Comentarios a estos manuales

Sin comentarios