Cisco WS-X4515 - Supervisor Engine IV Manual de usuario descargar pdf (Pagina 16)

Chapter 1 Product Overview

Supervisor Engines

1-16

Catalyst 4500 Series Installation Guide

78-14409-03 B0

• Reset Button, page 1-17

• Flash Port, page 1-18

LEDs

Table 1-4 describes the supervisor engine LEDs.

Gigabit Ethernet Uplink Ports

The Gigabit Ethernet uplink ports operate in full-duplex mode only. GBICs have

SC connectors to interface with multimode fiber (MMF) and single-mode fiber

(SMF) cable. For more information about GBICs, refer to the Catalyst 4000

Family Module Installation Guide.

Table 1-4 Supervisor Engine LEDs

LED Color/State Description

STATUS Indicates the results of a series of self-tests:

Green All diagnostic tests passed.

Red A test failed.

Orange System boot or diagnostic test is in progress.

Off Module is disabled.

UTILIZATION Green 1–100% If the switch is operational, this display indicates the current

traffic load over the backplane (as an approximate percentage).

LINK Indicates the status of the 10/100BASE-T port or uplink ports:

Green The link is operational.

Orange The link is disabled by user.

Flashing orange The power-on self-test indicates a faulty port.

Off No signal is detected or there is a link configuration failure.

ACTIVE Indicates whether the uplink port is active or not:

Green The port is active.

Off The port is not active.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Cisco WS-X4515 - Supervisor Engine IV Manual de usuario Pagina 16