Cisco ASR 1001 Guía de instalación descargar pdf (Pagina 22)

11-338

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide

OL-13208-11

Chapter 11 Cisco ASR 1001 Router Overview and Installation

Installing the Cisco ASR 1001 Router in a Rack

Figure 11-15 shows where to attach the front rack-mount brackets to the Cisco ASR 1001 Router.

Figure 11-15 Attaching the Front Rack-Mount Brackets to the Cisco ASR 1001 Router

Step 2

Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes.

Step 3 Insert and tighten the black screws on one side.

Step 4 Repeat Step 1 through Step 3 on the other side of the chassis. Use black screws to secure the rack-mount

brackets to the chassis.

This completes the steps for attaching the front rack-mount brackets to the Cisco ASR 1001 Router.

Installing the Cisco ASR 1001 Router in a Rack

After installing the rack-mount brackets on the chassis, you mount the chassis by securing the

rack-mount brackets to two posts or mounting strips in the rack using the screws provided. Because the

rack-mount brackets support the weight of the entire chassis, be sure to use all screws to fasten the two

rack-mount brackets to the rack posts.

Warning

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special

precautions to ensure that the system remains stable. The following guidelines are provided to ensure

your safety:

-This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

-When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the

heaviest component at the bottom of the rack.

-If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing

the unit in the rack.

Statement 1006

We recommend that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between the

router and any equipment directly above and below it.

To install the chassis in the rack, perform the following steps:

Step 1 On the chassis, ensure that all screw fasteners on the installed components are securely tightened.

1 Front rack-mount bracket ear and holes 3 Front rack-mount bracket screws

2 Front rack-mount bracket — —

279911

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Sin comentarios

Cisco ASR 1001 Guía de instalación Pagina 22