Cisco ASR 1001 Guía de instalación descargar pdf (Pagina 30)

11-346

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide

OL-13208-11

Chapter 11 Cisco ASR 1001 Router Overview and Installation

Connecting the Shared Port Adapter Cables

The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1001

Router are contained in the respective configuration documents for each port adapter. For example, if

you are connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port

Adapter Installation and Configuration at the following location:

http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-po

s-oc3_install_config/paposoc3.html

Connecting the Console and Auxiliary Port Cables

This section describes how to attach a cable to the Cisco embedded ASR1000-RP1 console or auxiliary

ports on the Cisco ASR 1001 Router. The Cisco ASR 1001 Router uses RJ-45 ports for both the auxiliary

port and console port to attach a modem or console terminal.

Caution Both the console and the auxiliary ports are asynchronous serial ports; any devices connected to these

ports must be capable of asynchronous transmission. (Asynchronous is the most common type of serial

device; for example, most modems are asynchronous devices.) To meet Class A emissions requirements,

shielded cables must be used for the console and auxiliary port connectors.

Before you can use the console interface on the router using a terminal or PC, you must perform the

following steps:

Step 1 Before connecting a terminal to the console port, configure the terminal to match the chassis console

port as follows: 9600 baud, 8 data bits, no parity, 1 stop bits (9600 8N1).

Step 2 Connect to the port using the RJ-45 to DB-9 cable.

Note For information about how to change the default settings to meet the requirements of your terminal or

host, see Cisco IOS Terminal Services Configuration Guide.

Step 3 After you establish normal router operation, you can disconnect the terminal.

Management Ethernet Port Cable Connection

Caution To comply with Class A emissions requirements, a shielded Ethernet cable must be used for the

connection.

To use the Management Ethernet interface on the router, perform the following steps:

Step 1 Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see Figure 11-7).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Sin comentarios

Cisco ASR 1001 Guía de instalación Pagina 30