Cisco PIX 525 Especificaciones descargar pdf (Pagina 64)

100

101

5-4

Cisco Security Appliance Command Line Configuration Guide

OL-6721-01

Chapter 5 Adding and Managing Security Contexts

Configuring a Security Context

Specify the interface name if you want to override the route to the server address.

The filename does not require a file extension, although we recommend using “.cfg”.

The admin context file must be stored on the internal Flash memory.

If you download a context configuration from an HTTP or HTTPS server, you cannot save changes back

to these servers using the copy running-config startup-config command. You can, however, use the

copy tftp command to copy the running configuration to a TFTP server.

If the system cannot retrieve the context configuration file because the server is unavailable, or the file

does not yet exist, the system creates a blank context that is ready for you to configure with the

command-line interface.

To change the URL, reenter the config-url command with a new URL.

See the “Changing the Security Context URL” section on page 5-6 for more information about changing

the URL.

For example, enter the following command:

hostname(config-ctx)# config-url ftp://joe:[email protected]/configlets/test.cfg

Step 5 To view context information, see the show context command in the Cisco Security Appliance Command

Reference.

The following example sets the admin context to be “administrator,” creates a context called

“administrator” on the internal Flash memory, and then adds two contexts from an FTP server:

hostname(config)# admin-context administrator

hostname(config)# context administrator

hostname(config-ctx)# allocate-interface gigabitethernet0.1

hostname(config-ctx)# allocate-interface gigabitethernet1.1

hostname(config-ctx)# config-url flash:/admin.cfg

hostname(config-ctx)# context test

hostname(config-ctx)# allocate-interface gigabitethernet0.100 int1

hostname(config-ctx)# allocate-interface gigabitethernet0.102 int2

hostname(config-ctx)# allocate-interface gigabitethernet0.110-gigabitethernet0.115

int3-int8

hostname(config-ctx)# config-url ftp://user1:[email protected]/configlets/test.cfg

hostname(config-ctx)# context sample

hostname(config-ctx)# allocate-interface gigabitethernet1.200 int1

hostname(config-ctx)# allocate-interface gigabitethernet1.212 int2

hostname(config-ctx)# allocate-interface gigabitethernet1.230-gigabitethernet1.235

int3-int8

hostname(config-ctx)# config-url ftp://user1:[email protected]/configlets/sample.cfg

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 603 604

Comentarios a estos manuales

Sin comentarios

Cisco PIX 525 Especificaciones Pagina 64

Comentarios a estos manuales