Cisco 11.0 BT Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 30
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
2-22 TN3270 Design and Implementation Guide
PU Configuration Mode
You access the PU configuration mode from the TN3270 Server configuration mode or from the DLUR
configuration mode. In either mode, the pu command puts you in PU configuration mode.
For direct PUs, from TN3270 configuration mode issue the pu command to create a new PU:
pu pu-name idblk-idnum ip-address type adapno lsap [rmac rmac] [rsap rsap] [lu-seed lu-name-stem]
The following prompt appears:
tn3270-pu>
For DLUR PUs, from DLUR configuration mode issue the pu command to create a new PU:
pu pu-name idblk-idnum ip-address
The following prompt appears:
tn3270-dlur-pu>
From either mode, to return to PU configuration mode on PU pu-name the command is:
pu pu-name
Moving Between Configuration Modes
Some configuration commands create entities on the CIP or CPA. For most of these, the command changes to the
mode associated with that entity (for example, a PU). In general, the parameters provided to create the entity
come in two sets: those that identify the specific instance of the entity (for example, a PU name) and those that
merely set operating parameters. To return to the mode, the same command is used but with only the first set of
parameters. Tables 2-2, 2-3, and 2-4 show example tasks to return to a command mode without creating a new
entity.
To create a DLUR LSAP and enter DLUR LSAP configuration mode, perform the following task beginning in
TN3270 DLUR configuration mode:
To return later to the DLUR LSAP configuration mode on the same entity, perform the following task beginning
in TN3270 DLUR configuration mode:
Table 2-2 DLUR LSAP Configuration Mode
Task Command
Create a DLUR LSAP and enter DLUR LSAP
configuration mode.
lsap token-adapter 1 84
Table 2-3 Returning to DLUR LSAP Configuration Mode
Task Command
Enter DLUR LSAP configuration mode on the
same LSAP.
lsap token-adapter 1
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Comentarios a estos manuales

Sin comentarios