Cisco GoQAM Información técnica descargar pdf (Pagina 39)

Command Syntax

4025561 Rev

01/06 MODULE>

 In the first line of this example, the operator selects the Module command mode.

 In the next line, the prompt has changed to reflect the new command mode. The

operator then selects chassis 1, slot 6 as the target for subsequent commands.

 On pressing Enter, the prompt then changes from */* MODULE> to 01/06

MODULE> to show the selection of chassis 1, slot 6 in effect.

 Next, the operator types the alarm module command.

 On pressing Enter, the system response "No active alarms found for the specified

module range" reflects the alarm status of the module in chassis 1, slot 6 of the

current ICIM2 domain.

Modal command entry is often helpful for human operators. It can minimize the

need for keystrokes in some cases, thus saving time and eliminating a possible

source of error. Modal operation can also help streamline the work flow by focusing

commands and human attention on a particular chassis or module of interest.

Non-Modal Command Syntax

The general format for a non-modal CLI command, as usually sent from an element

management system, is as follows:

modeName modeOptions Action actionOptions Values Exit

The parameters in the command have the same functions as in modal command

entry:

Keyword Function

modeName The name of a mode switch: cli, module, icim, or terminal.

modeOptions Options that may be associated with the modename.

Action A command keyword such as set, show, info, etc.

actionOptions Options that may be associated with the action.

Values Values that may be associated with the action.

Exit Used to return to CLI command mode.

Example

A non-modal command is entered without changing command modes. For example,

the alarm module command shown above could have been entered as follows:

CLI> module chassis 1 slot 6 exit

SUCCESS!

CLI> module alarm module exit

No active alarms found for the specified module range

SUCCESS!

CLI>

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 307 308

Sin comentarios

Cisco GoQAM Información técnica Pagina 39