Cisco GoQAM Información técnica descargar pdf (Pagina 76)

Cha

4 Module Mode Commands

52 4025561

Rev

info alarm

Syntax

info alarm alarmName detail1 detail2 . . . detailn

Description

The info alarm command is used to display more detailed alarm information than is

returned by using the show command.

Parameters

The alarmName parameter specifies the type of alarm. The allowable alarmName

values vary by module because different modules have different types of alarms. To

learn about possible alarms for each module, do one of the following:

 Use the modid command to select a single module (by chassis and slot location),

and then issue the command alarmstate * to list all available alarm names.

 When entering this command, do not use the letter h to abbreviate hysteresis, as

this will instead invoke the help command.

 See Module Parameter Descriptions (on page

245) for a list of possible alarms for

each module.

The detail parameters specify the characteristics that can be requested for each

alarmName, as follows:

Detail parameter Description

Hysteresis Threshold hysteresis value.

Index Alarm number, starting at 1, in the list of alarms.

Label Name of the alarm.

Limitadjust Allowed if alarm is adjustable, not allowed if not.

Majorhigh High Major threshold.

Majorlow Low Major threshold.

Minorhigh High Minor threshold.

Minorlow Low Minor threshold.

Nominal Alarm nominal value.

Rangehi Upper limit for this threshold.

Rangelo Lower limit for this threshold.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 307 308

Sin comentarios

Cisco GoQAM Información técnica Pagina 76