Cisco GoQAM Información técnica descargar pdf (Pagina 94)

Cha

4 Module Mode Commands

70 4025561

Rev

Non-Boolean alarms also have a hysteresis setting that can be used to adjust the

amount of change required to switch states. For possible hysteresis values, see

Module Parameter Descriptions (on page

245). For additional information, see the

SNMP Management section of the Prisma II Enhanced Management System Guide,

System Release 2.04, part number 4025559.

With regard to the set alarmparam command, alarm types 1, 2, and 7 in the table

above are the only types with thresholds that may be changed by a user. These

alarms also share in common that they will not cause a module to shut down. Any

attempt to use set alarmparam to change the parameter of an alarm not of type 1, 2,

or 7 will result in an error message.

Parameters

The possible values for alarmName, alarmParamName, and alarmParamValue

depend on the application module in question. The following tables identify the

alarms for each application module. For details on alarm parameters and their

possible values, see Module Parameter Descriptions (on page

245).

Note:

 When selecting parameters for this command, one or more wildcard characters

(*) may be used to specify a range of matching responses.

 When entering this command, do not use the letter h to abbreviate hysteresis, as

this will instead invoke the help command.

Fan Tray (devtype: 5012)

alarmName Description

FansOK Fan operating status.

ChasTemp Chassis fan tray temperature.

Power Supply, Slot 1 (devtype: 5013)

alarmName Description

Ps1PwrIn Power supply 1 input power status.

Ps1+24 Power supply 1 +24 V bus voltage.

Ps1+5VDC Power supply 1 +5 V bus voltage.

Ps1-5VDC Power supply 1 -5 V bus voltage.

Power Supply, Slot 3 (devtype: 5013)

alarmName Description

Ps3PwrIn Power supply 3 input power status.

Ps3+24 Power supply 3 +24 V bus voltage.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 307 308

Sin comentarios

Cisco GoQAM Información técnica Pagina 94