Cisco 7246 - uBR Router Manual de usuario descargar pdf (Pagina 60)

Command Reference

12.0(3)T

show interface cable

To display cable interface information, use the show interface cable privileged EXEC command.

show interface cable slot/port [downstream | upstream]

Syntax Description

Default

No default behavior or values.

Command Mode

Privileged EXEC

Command History

Sample Display

The following is sample output for the cable modem located in slot 6/port 0 from the show interface

cable command:

router# show interface cable 6/0

Cable6/0 is up, line protocol is up

Hardware is BCM3210 FPGA, address is 00e0.1e5f.7a60 (bia 00e0.1e5f.7a60)

Internet address is 1.1.1.3/24

MTU 1500 bytes, BW 27000 Kbit, DLY 1000 usec, rely 255/255, load 1/255

Encapsulation, loopback not set, keepalive not set

ARP type: ARPA, ARP Timeout 04:00:00

Last input 4d07h, output 00:00:00, output hang never

Last clearing of “show interface” counters never

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

10908 packets input, 855000 bytes, 0 no buffer

Received 3699 broadcasts, 0 runts, 0 giants, 0 throttles

3 input errors, 3 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

5412 packets output, 646488 bytes, 0 underruns

0 output errors, 0 collisions, 13082 interface resets

0 output buffer failures, 0 output buffers swapped out

slot/port Identiﬁes the Cisco uBR7200 chassis slot number and

downstream port number. Valid values are from 3 to 6.

downstream (Optional) Displays cable downstream port information for a

cable modem.

upstream (Optional) Displays cable upstream port information for a

cable modem.

Release Modiﬁcation

11.3 XA This command was ﬁrst introduced.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 77 78

Sin comentarios

Cisco 7246 - uBR Router Manual de usuario Pagina 60