Cisco 7246 - uBR Router Manual de usuario descargar pdf (Pagina 69)

test cable atp cable

Cisco uBR7246 Universal Broadband Router Feature Enhancements 69

test cable atp cable

To run the acceptance test procedure on a port, use the test cable atp cable privileged EXEC

conﬁguration command.

test cable atp cable slot/port MAC-address category test-id

Syntax Description

Default

No default behavior or values.

Command Mode

Privileged EXEC

Command History

Usage Guidelines

You should read and understand the ATP documentation before using this command.

The ATP tests are organized into categories such as PHY, MP, MAC, and so forth. Tests within each

category are labeled MP01, MP02, ..., MAC01, MAC02, and so forth. If you run a test from the CLI,

you can omit the leading zero in the test ID.

In this release, Cisco supports only a subset of all of the tests.

Examples

The following example tests the upstream cable interface located in slot 2/port 0 at MAC address

1.1.1. The test speciﬁed is MAC-PHY test 4 (MP-04).

Router# test cable atp cable 2/0 1.1.1 mp 4

Running Upstream Channel Change (MP-04)

Testing MP_04_UCD_FREQ_CHANGE

Setting the upstream to 30MHz through UCD.

slot/port Speciﬁes upstream cable interface by slot and port number.

MAC-address Speciﬁes the MAC address of the cable modem.

category Speciﬁes the test category as being mac for MAC tests or mp for

MAC-PHY tests. Valid MAC tests are 1 through 15. Valid

MAC-PHY tests are 4 through 7. These categories of tests are

described in the ATP documentation.

test-id Identiﬁes a test speciﬁed in the automatic test procedure (ATP)

documentation. The ATP documentation describes the collection

of tests and the categories into which these tests are divided.

Release Modiﬁcation

11.3(6)NA This command was ﬁrst introduced.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 77 78

Sin comentarios

Cisco 7246 - uBR Router Manual de usuario Pagina 69