Cisco 7301 Información técnica descargar pdf (Pagina 21)

7 Configure the Router

Before configuring the router, determine whether or not you want to use a management tool such as Cisco Security Device

Manager.

Cisco Security Device Manager (SDM), version 1.1, is an optional Java-based device-management tool that allows you to

configure LAN interfaces, routing, Network Address Translation (NAT), firewalls, Virtual Private Networks (VPNs), and other

features without knowledge of the Cisco command-line interface (CLI). You can configure features such as Access Control Lists

(ACLs), routing protocols, and other options using SDMs advanced mode.

Note You will need to use CLI commands to configure several features that SDM does not support. SDM does not support

the following features: WAN configuration, Gigabit Ethernet (GE) interfaces, AA client, EZ VPN server, QoS,SSHv2,

DHCP server configuration options, and usability enhancements.

SDM is preinstalled on your routers Flash Disk or CompactFlash Disk when it is ordered as part of a VPN bundle or as part of

a 7xxx VPN bundle. If your router did not ship with SDM preinstalled, you can download a free copy from the Software Center

at Cisco.com at http://ww.cisco.com/kobayashi/sw-center/index.shtm. Because SDM uses a GUI, it requires that you access it

from a PC using a supported web browser. Go to the Security Device Manager (SDM), Version 1.1 User Note for the 7xxx

Routers for more information.

Performing a Basic Configuration Using the Setup Facility

If you do not plan to use AutoInstall, do not connect the router’s serial (WAN) cable to the channel service unit/data service

unit (CSU/DSU). If the WAN cable is not connected, the router boots from Flash memory and goes automatically into the setup

facility.

You can run the setup facility any time you are at the enable prompt (#) by entering the setup command.

If the serial (WAN) cable is connected to the CSU/DSU and the router does not have a configuration stored in NVRAM, the

router attempts to run AutoInstall at startup. The router may take several minutes to determine that AutoInstall is not set up

to a remote TCP/IP host. Once the router determines that AutoInstall is not configured, it defaults to the setup facility.

Configure Global Parameters

When you first start the setup program, you must configure the global parameters. These parameters are used for controlling

system-wide settings. Complete the following steps to enter the global parameters:

Step 1 Connect a console terminal to the console port, and then boot the router.

The system boots from Flash memory. The following information appears after about 30 seconds. When you see this

information, you have successfully booted your router:

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

Rights clause at FAR sec. 52.227-19 and subparagraph

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 7301 Software (C7301-JS-M), Experimental Version 12.2(20030103:230909) [biff 100]

Compiled Fri 03-Jan-03 16:03 by biff

Image text-base:0x600088F4, data-base:0x617F6000

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Sin comentarios

Cisco 7301 Información técnica Pagina 21