Cisco 7301 Información técnica descargar pdf (Pagina 28)

Configure IP on this interface? [yes]:

IP address for this interface: 1.1.1.10

Number of bits in subnet field [0]: 0

Class C network is 1.1.1.0, 0 subnet bits; mask is /24

Configure IPX on this interface? [yes]:

IPX network number [2]:

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]:

The following configuration command script was created:

hostname Router

enable secret 5 $1$u8z3$PMYY8em./8sszhzk78p/Y0

enable password betty

line vty 0 4

password fred

snmp-server community public

ip routing

no vines routing

ipx routing

appletalk routing

no apollo routing

no decnet routing

no xns routing

no clns routing

no bridge 1

! Turn off IPX to prevent network conflicts.

interface ATM1/0

ip address 1.1.1.10 255.0.0.1

appletalk cable-range 0-0 0.0

appletalk discovery

router igrp 15

network 1.0.0.0

end

Use this configuration? [yes/no]: yes

Building configuration...

Use the enabled mode ‘configure’ command to modify this configuration.

Press RETURN to get started!

Yourrouter is now minimally configured and ready to use. You can use the setup command if you want to modify the parameters

after the initial configuration. To perform more complex configurations, use the configure command.

For information on additional interface configuration and specific system configurations, refer to the modular configuration and

modular command reference publications in the Cisco IOS software configuration documentation set that corresponds to the

software release installed on your Cisco hardware.

Save the Running Configuration to NVRAM

To store the configuration or changes to your startup configuration in NVRAM, enter the copy running-config startup-config

command at the

Router# prompt:

Router# copy running-config startup-config

Using this command saves the configuration settings that you created in the router using configuration mode and the setup

facility. If you fail to do this, your configuration will be lost the next time you reload the router.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comentarios a estos manuales

Sin comentarios

Cisco 7301 Información técnica Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 7301