Cisco 7301 Información técnica descargar pdf (Pagina 30)

8 After Installation

Follow the instructions in this section to replace options after installation. Use the installation and removal information in this

section to power off the router, remove the cover, replace the option, replace the cover, and power on the router.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Before working on a chassis or working near power supplies, unplug the power cord on AC units; disconnect the

power at the circuit breaker on DC units.

Warning

When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to the card. Some

platforms have an ESD connector for attaching the wrist strap. Do not directly touch the system board with your

hand or any metal tool, or you could shock yourself.

Power Off the Cisco 7301 Router

Step 1 Power off the router by placing the power switch in the OFF (|) position.

Step 2 Remove any cables from the Cisco 7301 router, including the power cables. For AC power supplies, unplug the AC

power cord from the power outlet. For DC power supplies, to ensure that all power is off, locate the circuit breaker on

the panel board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle

of the circuit breaker in the OFF position.

Note After powering off the router, wait a minimum of 30 seconds before powering it on again.

Replace the CompactFlash Disk

Figure 19 Inserting and Removing the CompactFlash Disk

To remove the CompactFlash Disk, press the ejector button, grasp the CompactFlash Disk and pull it from the slot (2).

Insert the CompactFlash Disk

Press the ejector button and remove the CompactFlash

Disk

80270

ALARM

ONSOLE

COMPACT

FLASH

STATUS

100-240V, 2A, 50/60 Hz

24V

9A, 48 - 60V

ALARM

ONSOLE

COMPACT

FLASH

STATUS

100-240V, 2A, 50/60 Hz

24V

9A, 48 - 60V

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Sin comentarios

Cisco 7301 Información técnica Pagina 30