Cisco 7301 Información técnica descargar pdf (Pagina 22)

cisco 7301 (NPE-G1) processor (revision A) with 245760K/16384K bytes of memory.

Processor board ID 0

SB-1 CPU at 650Mhz, Implementation 1, Rev 0.2, 512KB L2 Cache

1 slot midplane, Version 2.0

Last reset from power-on

Bridging software.

X.25 software, Version 3.0.0.

TN3270 Emulation software.

3 Gigabit Ethernet/IEEE 802.3 interface(s)

509K bytes of non-volatile configuration memory.

125440K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).

32768K bytes of Flash internal SIMM (Sector size 256K).

Press RETURN to get started!

The first two sections of the configuration script (the banner and the installed hardware) appear only at initial system

startup. On subsequent uses of the setup facility, the script begins with a System Configuration Dialog as shown in the

following example.

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Step 2 When asked if you want to enter the initial configuration dialog and see the current interface summary, enter yes or

press Return:

Would you like to enter the initial configuration dialog? [yes]:

First, would you like to see the current interface summary? [yes]:

In the following example, the summary shows a Cisco 7301 router at first-time startup; that is, nothing is configured.

Any interface listed with OK? value "NO" does not have a valid configuration

Interface IP-Address OK? Method Status Protocol

ATM1/0 unassigned NO unset down down

FastEthernet1/0 unassigned NO unset down down

Step 3 Choose which protocols to support on your interfaces. For Internet Protocol (IP)-only installations, you can accept the

default values for most of the questions. A typical configuration using IP, IPX, and AppleTalk follows and continues

through Step 8:

Configuring global parameters:

Enter host name [Router]:

Step 4 Enter enable secret, enable, and virtual terminal passwords:

The enable secret password is a one-way cryptographic secret

password used instead of the enable password when it exists.

Enter enable secret: barney

The enable password is used when there is no enable secret

password and when using older software and some boot images.

Enter enable password: betty

Enter virtual terminal password: fred

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Sin comentarios

Cisco 7301 Información técnica Pagina 22