Cisco 827 - 827 Router - EN Manual de usuario descargar pdf (Pagina 20)

Network Scenarios Pagina 20 di 35

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/827/827swcfg/ntwkscen.htm 14/02/2001

l Configuring VoIP Dial Peers for H.323 Signaling

l Configuration Example

To add additional features to this network, refer to "Feature-By-Feature Router Configurations."

After configuring your router, you need to configure the PVC endpoint. For a general configuration

example, refer to "Cisco 3640 Gateway Configuration Example" at the end of this chapter.

Specifying CRB and Configuring the Ethernet Interface

Use this table to specify CRB and configure the Ethernet interface, beginning in global configuration

mode.

Configuring the ATM Interface and Subinterfaces

Use this table to configure the ATM interface and subinterfaces, beginning in global configuration mode.

Step Task Router

Prompt

Command

1 .

Specify CRB. Router

(config)#

bridge crb

2 .

Enter configuration mode for the Ethernet

interface.

Router

(config-if)#

interface

ethernet 0

3 .

Specify the bridge-group number to which

the Ethernet interface belongs.

Router

(config-if)#

bridge-group 1

4 .

Exit configuration mode for the Ethernet

interface and the router.

Router

(config-if)#

exit

5 .

Specify the bridge protocol to define the type

of STP.

Router

(config-if)#

bridge 1

protocol ieee

Step Task Description Router

Prompt

Command

1 .

Specify the ATM0.1 subinterface. Router

(config-if)#

interface ATM 0.1

point-to-point

2 .

Set the IP address and subnet mask for

the ATM0.1 subinterface.

Router

(config-if)#

ip address 1.0.0.1

255.255.255.0

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 34 35

Comentarios a estos manuales

Sin comentarios

Cisco 827 - 827 Router - EN Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 827 - 827 Router - EN