Cisco Catalyst 4224 Especificaciones Pagina 142

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 310
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 141
Chapter 5 Configuring the Voice Interfaces
T1/E1 Configuration (H.323)
5-34
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
b. Configure each channel group as a virtual serial interface.
c4224(config-controller)# interface serial 1/0:31
c. Specify the E1 interface, unit number, and channel group to modify, as in the
following example:
interface Serial1/0:23
no ip address
no logging event link-status
isdn switch-type primary-5ess
isdn incoming-voice voice
no cdp enable
Note After completing these steps, configure the route pattern and dial plan and
save your configuration, as described in H.323 Gateway Configuration
section on page 5-16.
E1/PRI Configuration Example
isdn switch-type primary-5ess
isdn voice-call-failure 0
controller E1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-31
interface Serial 1/0:15
no ip address
no logging event link-status
isdn switch-type primary-5ess
isdn incoming-voice voice
no cdp enable
Vista de pagina 141
1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 309 310

Comentarios a estos manuales

Sin comentarios