Cisco Catalyst 4224 Especificaciones descargar pdf (Pagina 48)

Chapter 1 Product Overview

Recommended Configurations

1-22

Catalyst 4224 Access Gateway Switch Software Configuration Guide

OL-2031-02

Interface Range Command Support

You can use the range command. The following sample configuration shows how

to configure the range command:

C4224_SF(config)# int range fas5/2 - 5

switchport access vlan 60

switchport voice vlan 160

Switched Port Analyzer (SPAN)

Switched Port Analyzer (SPAN), also known as port monitoring, is supported for

up to two sessions. Spanning a VLAN is not supported. You can only span

selected interfaces. The following sample configuration shows a configuration for

setting a port monitor session with the range command:

C4224_SF(config)# monitor session 1 ?

destination SPAN destination interface or VLAN

source SPAN source interface or VLAN

Recommended Configurations

This section contains the following topics:

• No VTP or DTP Support, page 1-23

• Creating a VLAN, page 1-23

• Defining a VLAN on a Trunk Port, page 1-23

• Trunking, page 1-24

• Fractional PRI Configuration, page 1-24

• No Ring Back Tone Generated, page 1-25

• MTP Required on Cisco CallManager, page 1-26

• H323-Gateway VOIP Bind SRCADDR Command, page 1-27

• Port Fast Not Enabled on Trunk Ports, page 1-28

• Priority Queuing on Frame Relay, page 1-28

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 309 310

Sin comentarios

Cisco Catalyst 4224 Especificaciones Pagina 48