Cisco CX-FEIP-2TX= Installation and con?guration Manual de usuario descargar pdf (Pagina 17)

HP OpenView NetMetrix/UX Release Notes version 6.0

October 1, 1998

Known Problems and Work-Arounds

16 October 1, 1998

Known Problems and Work-Arounds

The following pages describe issues and work-arounds for version 6.0.

For additional troubleshooting information, refer to the Troubleshooting

section beginning on page 51 in Installation.

Many common problems are ﬁxed by patches to the operating system, to

HP OpenView Network Node Manager, and to the Emanate SNMP

agent. Consequently, you should verify that your system has the required

patches for NetMetrix. Refer to the ﬁle /doc/req_patches.txt on the

NetMetrix CD-ROM for details.

General

Description Installation fails on HP-UX 10.x system when transition links are

not installed.

Details The NetMetrix installation for HP-UX 10.x relies on the transition sym-

bolic links, which are normally present on the system. If the transition

links have been removed, the NetMetrix installation will fail.

[Defect ID 5003–357384]

Work-Around If necessary, install the transition links prior to installing NetMetrix.

Description Installation fails with message: “netmd cannot fork, exit code=2”

Details If you install the Extended RMON Module (Mid-Level Manager or MLM

ﬁleset), the installation will register the ERM and attempt to start it. If

the host system does not have sufﬁcient memory and/or swap space to

start the ERM, the following message is shown repeatedly:

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 50 51

Sin comentarios

Cisco CX-FEIP-2TX= Installation and con?guration Manual de usuario Pagina 17