Cisco Explorer 8300 Guía de usuario descargar pdf (Pagina 15)

EXPLORER® SÉRIES 8000 & 8300 REMOTE CONTROLS ND PNEL (CONTINUED)

Programming a second TV to AUX Mode

1. Press the AUX button to be programmed and the SELECT button simultaneously for 3 seconds. The AUX device LED will

turn on.

Tip: The device LED will turn on for 20 seconds. The next step must be entered while the LED is on.

2. Press the TV device button to pick up the TV code table.

3. Point the remote control toward the equipment and enter the three-digit code number assigned to your TV brand from

the code tables.

4. Store the three-digit code number by pressing the AUX button once again. The device LED will blink twice to confirm

that the code has been stored.

Programming the System On/Off Button

This is designed to program the System On/Off button so that it can send out up to five power on/off commands with

one button press.

1. Press the CBL button.

2. Press the SYSTEM ON/OFF button and the SELECT button simultaneously for 3 seconds. The CBL button will turn on for

20 seconds.

3. Press the device button and the POWER button you wish to store in the SYSTEM ON/OFF button and repeat this until

you stored all the power commands into the SYSTEM ON/OFF button.

4. Press the CH+ button to save the power commands you stored. The CBL button will blink twice to confirm the saving.

Programming Channel Control

By following the steps below, the user can program the channel controls (Channel Up, Channel Down and Last) from one

device to operate in another device mode. The default channel control settings on the remote control are as follows:

CBL : CBL TV : CBL VCR : CBL DVD : DVD AUX : AUX

If you wish to store the TV channel control in TV mode, use the following steps.

1. Press the TV button and the SELECT button simultaneously for 3 seconds. The TV device LED will turn on.

Tip: The device LED will light on for 20 seconds. The next step must be entered while the LED is on.

2. Press the VOL- button.

3. Press the TV button. The device LED will blink twice to confirm the programming.

To return to original state: If you wish to restore the CABLE channel control in TV mode, repeat the above

steps by pressing CBL in step 3.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 70 71

Sin comentarios

Cisco Explorer 8300 Guía de usuario Pagina 15