Cisco Explorer 8300 Guía de usuario descargar pdf (Pagina 54)

EXPLORER

HDTV SETUP WIZRD (CONTINUED)

480i CH+ 480i SEt

720p VOL– 720p SEt

480p CH– 480p SEt

1080i VOL+ 1080 SEt

To select this

picture format:

Press this

button on the

Front Panel:

The set-top

briefly

displays:

And then

briefly

displays:

Prepare the set-top to send picture formats that your HDTV supports

If your HDTV displays a black screen when you turn it on, the set-top may be sending a picture format that your HDTV

does not support. Prepare the set-top to send all picture formats that your HDTV supports. Later, while watching TV, you

will be able to toggle among the different settings to select the format that provides the best picture quality for the pro-

gram you are watching.

Complete these steps to prepare the set-top to deliver programming in the picture format settings that your HDTV

supports.

Important: Before you start, read these instructions carefully.When you get to step 5 you have 20 seconds to begin

selecting picture format settings. After 20 seconds, the set-top is no longer in the Picture Format mode. If this occurs,

repeat this process, starting at step 2.

1. Refer to the user’s guide that came with your HDTV to find the picture formats that your HDTV supports.

2. If the set-top is turned off, press the POWER key to turn it on.

3. On the front of the set-top, press and hold the SELECT button until the Message Light blinks.

4. Then, press the VOL- key to indicate that you want to select a picture format setting. The LED display

shows HdSr to indicate that the set-top is in the Picture Format mode for HDTV settings.

5. In the following table, find each of the picture formats that your HDTV supports. Then, press the

corresponding buttons on the front panel of the set-top.

Note: If 1080i is one of the settings that your HDTV supports, we suggest you select it last. Then, when yo

u turn on the TV to

use the Setup Wizard, the picture format will be 1080i.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 70 71

Sin comentarios

Cisco Explorer 8300 Guía de usuario Pagina 54