Cisco Explorer 8300 Guía de usuario descargar pdf (Pagina 16)

EXPLORER® SÉRIES 8000 & 8300 REMOTE CONTROLS ND PNEL (CONTINUED)

Programming Volume Control

By following the steps below, the user can program the volume controls (Volume Up, Volume Down and Mute) from one

device to operate in another device mode. The default volume control settings on the remote control are as follows:

CBL : CBL TV : CBL VCR : CBL DVD : DVD AUX : AUX

If you wish to store the CBL volume control in CBL mode, use the following steps.

1. Press the CBL button and the SELECT button simultaneously for 3 seconds. The CBL device LED will turn on.

Tip: The device LED will turn on for 20 seconds. The next step must be entered while the LED is on.

2. Press the VOL+ button.

3. Press the CBL button. The device LED will blink twice to confirm the programming.

Programming For Advanced Function

In the CBL mode, the M1 button can be programmed to act as a macro or favorite channel button. You can send out up

to ten commands with one button press.

1. Press the CBL button to select the CBL mode.

2. Press the M1 button and SELECT button simultaneously for 3 seconds. The CBL device LED will turn on for 20 seconds.

3. Press up to 10 buttons you wish to store. The CBL device LED will blink once for each command entered.

4. Press the CH+ button to store the functions that were selected. The CBL device LED will blink twice to confirm

the storage of functions.

Low Battery Warning

When the batteries are low and need to be replaced with fresh batteries, the remote control LED will blink 2 times in

sequence whenever a POWER button is pressed to turn on equipment.

Memory Lock System

This remote control is designed to retain programmed memory for 10 years even after batteries are removed from the

remote control.

Write your device Set-up codes

TV ________________ VCR ________________ DVD ________________ AUX ________________

To return to original state: If you wish to restore the TV volume control in CBL mode, repeat the above

steps by pressing TV in STEP3.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 70 71

Sin comentarios

Cisco Explorer 8300 Guía de usuario Pagina 16