Cisco Cisco Access Registrar 4.2 Especificaciones Pagina 226

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 636
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 225
5-42
Cisco Wireless LAN Controller Configuration Guide
OL-13826-01
Chapter 5 Configuring Security Solutions
Configuring and Applying Access Control Lists
Note If you want to edit a rule, click the sequence number of the desired rule to open the Access
Control Lists > Rules > Edit page. If you ever want to delete a rule, hover your cursor over
the blue drop-down arrow for the desired rule and choose Remove.
j. Repeat this procedure to add any additional rules for this ACL.
Step 8 Click Save Configuration to save your changes.
Step 9 Repeat this procedure to add any additional ACLs.
Using the GUI to Apply Access Control Lists
Follow the instructions in these sections to apply ACLs using the controller GUI:
Applying an Access Control List to an Interface, page 5-42
Applying an Access Control List to the Controller CPU, page 5-43
Applying an Access Control List to a WLAN, page 5-44
Applying a Preauthentication Access Control List to a WLAN, page 5-45
Note If you apply an ACL to an interface or a WLAN, wireless throughput is degraded when downloading
from a 1-Gbps file server. To improve throughput, remove the ACL from the interface or WLAN, move
the ACL to a neighboring wired device with a policy rate-limiting restriction, or connect the file server
using 100 Mbps rather than 1 Gbps.
Applying an Access Control List to an Interface
Follow these steps to apply an ACL to a management, AP-manager, or dynamic interface using the
controller GUI.
Step 1 Click Controller > Interfaces.
Step 2 Click the name of the desired interface. The Interfaces > Edit page for that interface appears (see
Figure 5-27).
Vista de pagina 225
1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 635 636

Comentarios a estos manuales

Sin comentarios