Cisco Cisco Access Registrar 4.2 Especificaciones Pagina 514

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 636
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 513
12-6
Cisco Wireless LAN Controller Configuration Guide
OL-13826-01
Chapter 12 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid REAP
Note The addresses in this sample configuration are for illustration purposes only. The addresses that
you use must fit into your upstream network.
Sample local switch configuration:
ip dhcp pool NATIVE
network 10.10.100.0 255.255.255.0
default-router 10.10.100.1
!
ip dhcp pool LOCAL-SWITCH
network 10.10.101.0 255.255.255.0
default-router 10.10.101.1
!
interface FastEthernet1/0/1
description Uplink port
no switchport
ip address 10.10.98.2 255.255.255.0
spanning-tree portfast
!
interface FastEthernet1/0/2
description the Access Point port
switchport trunk encapsulation dot1q
switchport trunk native vlan 100
switchport trunk allowed vlan 100,101
switchport mode trunk
spanning-tree portfast
!
interface Vlan100
ip address 10.10.100.1 255.255.255.0
ip helper-address 10.10.100.1
!
interface Vlan101
ip address 10.10.101.1 255.255.255.0
ip helper-address 10.10.101.1
end
Configuring the Controller for Hybrid REAP
This section provides instructions for configuring the controller for hybrid REAP using either the GUI
or the CLI.
Using the GUI to Configure the Controller for Hybrid REAP
The controller configuration for hybrid REAP consists of creating centrally switched and locally
switched WLANs. Follow the steps in this section to use the GUI to configure the controller for these
WLANs. This procedure uses these three WLANs as examples:
WLAN Security Switching Interface Mapping (VLAN)
employee WPA1+WPA2 Central management (centrally switched
VLAN)
Vista de pagina 513
1 2 ... 509 510 511 512 513 514 515 516 517 518 519 ... 635 636

Comentarios a estos manuales

Sin comentarios