Cisco Cisco Access Registrar 4.2 Especificaciones descargar pdf (Pagina 521)

100

101

12-13

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 12 Configuring Hybrid REAPWireless Device Access

Configuring Hybrid REAP

Step 4 Choose H-REAP from the AP Mode drop-down box to enable hybrid REAP for this access point.

Note The last parameter on the Inventory tab indicates whether this access point can be configured for

hybrid REAP. Only the 1130AG, 1240AG, and 1250 access points support hybrid REAP.

Step 5 Click Apply to commit your changes and to cause the access point to reboot.

Step 6 Click the H-REAP tab to open the All APs > Details (H-REAP) page appears (see Figure 12-7).

Figure 12-7 All APs > Details (H-REAP) Page

If the access point belongs to a hybrid-REAP group, the name of the group appears in the HREAP Group

Name field.

Step 7 Check the VLAN Support check box and enter the number of the native VLAN on the remote network

(such as 100) in the Native VLAN ID field.

Note By default, a VLAN is not enabled on the hybrid-REAP access point. Once hybrid REAP is

enabled, the access point inherits the VLAN ID associated to the WLAN. This configuration is

saved in the access point and received after the successful join response. By default, the native

VLAN is 1. One native VLAN must be configured per hybrid-REAP access point in a

VLAN-enabled domain. Otherwise, the access point cannot send and receive packets to and from

the controller.

Step 8 Click Apply to commit your changes. The access point temporarily loses its connection to the controller

while its Ethernet port is reset.

Step 9 Click the name of the same access point and then click the H-REAP tab.

Step 10 Click VLAN Mappings to open the All APs > Access Point Name > VLAN Mappings page (see

Figure 12-8).

1 2 ... 516 517 518 519 520 521 522 523 524 525 526 ... 635 636

Comentarios a estos manuales

Sin comentarios

Cisco Cisco Access Registrar 4.2 Especificaciones Pagina 521

Comentarios a estos manuales