Cisco Cisco Access Registrar 4.2 Especificaciones descargar pdf (Pagina 302)

100

101

6-38

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 6 Configuring WLANsWireless Device Access

Configuring WLANs

Step 4 If you enabled the WLAN override feature in Step 3, check the check boxes for the WLANs that you

want this access point to broadcast.

Step 5 Click Apply to commit your changes.

Step 6 Click Save Configuration to save your changes.

Using the CLI to Configure WLAN Override

Use these commands to configure the WLAN override feature for a specific access point using the

controller CLI.

1. To enable or disable the WLAN override feature for a specific access point, enter this command:

config ap wlan {enable | disable} {802.11a | 802.11b} Cisco_AP

2. To define which WLANs you want to transmit, enter this command:

config ap wlan add {802.11a | 802.11b} wlan_id Cisco_AP

Configuring Access Point Groups

In a typical deployment, all users on a WLAN are mapped to a single interface on the controller.

Therefore, all users associated with that WLAN are on the same subnet or VLAN. However, you can

override this default WLAN setting to distribute the load among several interfaces or to group users based

on specific criteria such as individual departments (for example, marketing) by creating access point

groups (formerly known as site-specific VLANs). Additionally, these access point groups can be

configured in separate VLANs to simplify network administration, as illustrated in the example in

Figure 6-16.

Note The required access control list (ACL) must be defined on the router that serves the VLAN or subnet.

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 635 636

Comentarios a estos manuales

Sin comentarios

Cisco Cisco Access Registrar 4.2 Especificaciones Pagina 302

Comentarios a estos manuales