Cisco Cisco Aironet Wireless LAN Client Especificaciones descargar pdf (Pagina 62)

4-8

Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Linux

OL-1376-02

Chapter 4 Enabling Security Features

Using the Client Encryption Manager

Your client adapter authenticates to the RADIUS server by using your username and password and receives

a session-based WEP key.

Note After LEAP is enabled, the Server Based Authentication parameter can be used to disable or enable

LEAP as desired.

Note See the “Setting Network Security Parameters” section on page 5-5 for a comprehensive listing of all

network security parameters.

Synchronizing Security Features

In order to use any of the security features discussed in this section, both your client adapter and the

access point to which it associates must be set appropriately. Table 4-1 indicates the client and access

point settings required for each security feature. This chapter provides specific instructions for enabling

security features on your client adapter. Refer to the Cisco Aironet Access Point Software Configuration

Guide for instructions on enabling the features on the access point.

Table 4-1 Client and Access Point Security Settings

Security Feature Client Setting Access Point Setting

Static WEP with open

authentication

Create a WEP key and enable Use

Static WEP Keys and Open

Authentication

Set up and enable WEP and enable

Open Authentication

Static WEP with shared key

authentication

Create a WEP key and enable Use

Static WEP Keys and Shared Key

Authentication

Set up and enable WEP and enable

Shared Key Authentication

LEAP Authentication Enable LEAP Set up and enable WEP and enable

Network-EAP

MIC Use driver version 2.0 or greater

and firmware version 4.25.23 or

greater

Set up and enable WEP with full

encryption, set MIC to MMH, and

set Use Aironet Extensions to Yes

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 141 142

Sin comentarios

Cisco Cisco Aironet Wireless LAN Client Especificaciones Pagina 62