
7-5
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Linux
OL-1376-02
Chapter 7 Routine Procedures
Updating the Driver and Client Utilities
Figure 7-2 File Selection Window
Step 9
Find the location of the new firmware in the Files box. Double-clicking the directory button at the top
of the screen takes you to the directory indicated, and clicking the directory name moves you to that
directory.
Step 10 Under Files, click the new firmware image file (*.img) so that it appears in the Selection box at the
bottom of the File Selection window.
Step 11 Click OK. The selected image is loaded into the client adapter’s Flash memory.
Updating the Driver and Client Utilities
Instructions for updating the driver and client utilities are the same as for initially installing them. Refer
to the “Installing the Driver and Client Utilities” section on page 3-2.
Uninstalling the Driver and Client Utilities
If you experience difficulty while installing the driver, you might want to stop the installation procedure
and start over. However, before you attempt to install the driver again, you must first remove any part of
the driver that you might have already installed. You can remove the driver and client utilities manually,
or by running an uninstall script.
Uninstalling Manually
To uninstall the driver and client utilities manually, enter the following at the command line (excluding
the comment (#) lines).
#remove the utilities:
rm /opt/cisco/bin/acu
rm /opt/cisco/bin/bcard
rm /opt/cisco/bin/leapset
Comentarios a estos manuales