
5-19
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Linux
OL-1376-02
Chapter 5 Advanced Configuration
Overview
Figure 5-6 Advanced Ad Hoc Parameters Screen
Table 5-7 lists and describes the client adapter’s advanced ad hoc parameters. Follow the instructions in
the table to initially set or change any parameters.
Table 5-7 Advanced (Ad Hoc) Parameters
Parameter Description
Antenna Mode (Receive) Specifies the antenna that your client adapter uses to receive data.
• PC card—The PC card’s integrated, permanently attached
antenna operates best when used in diversity mode. Diversity
mode allows the card to use the better signal from its two antenna
ports.
Range: Diversity (Both), Right Antenna Only, Left Antenna Only
Default: Diversity (Both)
• LM card—The LM card is shipped without an antenna; however,
an antenna can be connected through the card’s external
connector. If a snap-on antenna is used, we recommend diversity
mode. Otherwise, select the mode that corresponds to the antenna
port to which the antenna is connected.
Range: Diversity (Both), Right Antenna Only, Left Antenna Only
Default: Diversity (Both)
• PCI client adapter—The PCI client adapter must use the Right
Antenna Only option
Default: Right Antenna Only
Antenna Mode (Transmit) Specifies the antenna that your client adapter uses to transmit data.
See the Antenna Mode (Receive) parameter above for information on
the options available for your client adapter.
Comentarios a estos manuales