Cisco MC3810-V - Concentrator - External Guía de instalación descargar pdf (Pagina 21)

Perform Initial Conﬁguration (continued)

NowthattheEthernetporthasanIPaddress,youcaneitherconﬁguretheCiscoMC3810remotelywithaTelnet

connection, or you can continue using the console or auxiliary port.

Note: The rest of this quick start guide contains basic conﬁguration instructions for the Cisco MC3810.

However, there are too many possible conﬁgurations to discuss in detail in this guide. Therefore, Cisco

recommends that you see the Cisco MC3810 Multiservice Access Concentrators Software Conﬁguration Guide

for all but the most basic conﬁgurations.

Note: For voice and video applications, a single master clock source must be established. For information

about conﬁguring synchronized clocking, see the chapter “Conﬁguring Synchronized Clocking” in the

Cisco MC3810 Series Multiservice Access Concentrators Software Conﬁguration Guide.

Step Command Purpose

router(config-if)# no shutdown

Messages similar to the following appear:

%LINEPROTO-5-UPDOWN: Line protocol on

Interface Ethernet0, changed state to up

%LINK-3-UPDOWN: Interface Ethernet0,

changed state to up

router(config-if)#

Activate the Ethernet port.

router(config-if)# exit

Return to global conﬁguration mode.

router(config)# line vty 0 4

Enter line conﬁguration mode.

router(config-line)# password

password

Set a password for remote access to the Cisco MC3810.

router(config-line)# end

Return to privileged EXEC mode.

router# copy system:running-config

nvram:startup-config

Messages similar to the following appear:

Building configuration...

Tablesize is 100

Configure call time

[OK]

router#

Save the conﬁguration.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sin comentarios

Cisco MC3810-V - Concentrator - External Guía de instalación Pagina 21