Cisco NM-16ESW - EtherSwitch Switch Manual de usuario descargar pdf (Pagina 13)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

Caution Changing the interface speed and duplex mode configuration might shut down and enable the interface

during the reconfiguration.

Configuring the Interface Speed

Beginning in global configuration mode, follow these steps to set the interface speed.

SUMMARY STEPS

1. interface gigabitethernet 0/slot/port

2. speed [10 | 100 | 1000 | auto]

DETAILED STEPS

Note If you set the interface speed to auto on a 10/100/1000-Mbps Gigabitethernet interface, both speed and

duplex are auto negotiated.

Configuring the Interface Duplex Mode

Beginning in interface configuration mode, follow these steps to set the duplex mode of a Gigabit

Ethernet interface.

SUMMARY STEPS

1. duplex [auto | full | half]

2. end

Command Purpose

Step 1

interface gigabitethernet 0/slot/port

Example:

Router(config)#interface gigabitethernet

0/1/2

Selects the interface to be configured.

The EHWIC slot number can be 0 to 3, and the EHWIC port

number can be 0 to 7.

Step 2

speed [10 | 100 | 1000 | auto]

Example:

Router(config-if)#speed 1000

Sets the interface speed of the interface.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 89 90

Sin comentarios

Cisco NM-16ESW - EtherSwitch Switch Manual de usuario Pagina 13