Cisco NM-16ESW - EtherSwitch Switch Manual de usuario descargar pdf (Pagina 40)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

Configuring Power Management on the Interface

This section describes how to configure power management on the interface and contains the following

topics:

• Configuring Power to Cisco IP Phones, page 40

• Configuring Maximum Inline Power Supply to a Port, page 41

• Verifying Power Management on the Interface, page 41

Configuring Power to Cisco IP Phones

Beginning in privileged EXEC mode, follow these steps to manage power to Cisco IP phones.

SUMMARY STEPS

1. configure terminal

2. interface gigabitethernet 0/slot/port

3. power inline auto

DETAILED STEPS

Command Purpose

Step 1

configure terminal

Example:

Router#configure terminal

Enters global configuration mode.

Step 2

interface gigabitethernet 0/slot/port

Example:

Router(config)#interface gigabitethernet 0/1/2

Selects a particular GigabitEthernet interface for

configuration.

Step 3

power inline auto

Example:

Router(config-if)#power inline auto

Configures the port to supply inline power automatically to

a Cisco IP phone. Use the power inline never command to

permanently disable inline power on the port.

Note On the Cisco ISR G2, the Cisco Gigabit EtherSwitch

EHWICs with POE modules does not provide inline

power to devices unless their speed and duplex

settings are both set to auto.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 89 90

Sin comentarios

Cisco NM-16ESW - EtherSwitch Switch Manual de usuario Pagina 40