Cisco NM-16ESW - EtherSwitch Switch Manual de usuario descargar pdf (Pagina 29)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

DETAILED STEPS

Displaying 802.1x Statistics and Status

To display 802.1x statistics for all interfaces, use the show dot1x statistics command in privileged

EXEC mode. To display 802.1x statistics for a specific interface, use the show dot1x statistics interface

type 0/slot/port in privileged EXEC mode.

To display the 802.1x administrative and operational status for the switch, use the show dot1x in

privileged EXEC mode. To display the 802.1x administrative and operational status for a specific

interface, use the show dot1x interface type 0/slot/port command in privileged EXEC mode.

Configuring Spanning Tree

• Enabling Spanning Tree, page 30

• Configuring Spanning Tree Port Priority, page 30

• Configuring Spanning Tree Port Cost, page 31

• Configuring the Bridge Priority of a VLAN, page 33

• Configuring the Hello Time, page 34

• Configuring the Forward-Delay Time for a VLAN, page 34

• Configuring the Maximum Aging Time for a VLAN, page 34

• Disabling Spanning Tree, page 35

Command Purpose

Step 1

configure terminal

Example:

Router#configure terminal

Enters global configuration mode.

Step 2

dot1x default

Example:

Router(config)#dot1x default

Resets the configurable 802.1x parameters to the default values.

Step 3

end

Example:

Router(config)#end

Returns to privileged EXEC mode.

Step 4

show dot1x

Example:

Router#show dot1x

Verifies your entries.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 89 90

Sin comentarios

Cisco NM-16ESW - EtherSwitch Switch Manual de usuario Pagina 29