Cisco NM-16ESW - EtherSwitch Switch Manual de usuario descargar pdf (Pagina 26)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

DETAILED STEPS

To return to the default retransmission time, use the no dot1x timeout tx-period command in global

configuration mode.

Setting the Switch-to-Client Frame-Retransmission Number

In addition to changing the switch-to-client retransmission time, you can change the number of times

that the switch sends an EAP-request/identity frame (assuming no response is received) to the client

before restarting the authentication process.

Note You should change the default value of this command only to adjust for unusual circumstances, such as

unreliable links or specific behavioral problems with certain clients and authentication servers.

Beginning in privileged EXEC mode, follow these steps to set the switch-to-client frame-retransmission

number.

SUMMARY STEPS

1. configure terminal

2. dot1x max-req count

3. end

4. show dot1x

Command Purpose

Step 1

configure terminal

Example:

Router#configure terminal

Enters global configuration mode.

Step 2

dot1x timeout tx-period seconds

Example:

Router(config)#dot1x timeout

tx-period 40

Sets the number of seconds that the switch waits for a response to an

EAP-request/identity frame from the client before retransmitting the

request.

The range is from 1 to 65535; the default is 30.

Step 3

end

Example:

Router(config)#end

Returns to privileged EXEC mode.

Step 4

show dot1x

Example:

Router#show dot1x

Verifies your entries.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 89 90

Comentarios a estos manuales

Sin comentarios

Cisco NM-16ESW - EtherSwitch Switch Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco NM-16ESW - EtherSwitch Switch