Cisco NM-16ESW - EtherSwitch Switch Manual de usuario Pagina 50

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 90
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 49
Configuring the Cisco Gigabit EtherSwitch EHWIC
How to Configure Gigabit EtherSwitch EHWICs
50
Configuring the Cisco Gigabit EtherSwitch EHWIC
OL-23155-01
DETAILED STEPS
Configuring Per-Port Storm-Control
You can use these techniques to block the forwarding of unnecessary flooded traffic. This section
describes how to configure per-port storm-control and characteristics on your router and consists of the
following configuration procedures:
Enabling Per-Port Storm-Control, page 50
Disabling Per-Port Storm-Control, page 52
By default, unicast, broadcast, and multicast suppression is disabled.
Enabling Per-Port Storm-Control
Beginning in privileged EXEC mode, follow these steps to enable per-port storm-control.
SUMMARY STEPS
1. configure terminal
2. interface type 0/slot/port
3. storm-control {broadcast | multicast | unicast} level level-high [level-low]
Command Purpose
Step 1
configure terminal
Example:
Router#configure terminal
Enters global configuration mode.
Step 2
ip igmp snooping vlan vlan-id mrouter
{interface interface-id | learn pim-dvmrp}
Example:
Router(config)#ip igmp snooping vlan 1
mrouter interface gigabitethernet0/1/2
Specifies the multicast router VLAN ID (1 to 1001).
Specifies the interface to the multicast router.
Step 3
end
Example:
Router(config)#end
Returns to privileged EXEC mode.
Step 4
show ip igmp snooping [vlan vlan-id]
Example:
Router#show ip igmp snooping vlan 1
Verifies that IGMP snooping is enabled on the VLAN interface.
Step 5
show ip igmp snooping mrouter [vlan vlan-id]
Example:
Router#show ip igmp snooping mrouter vlan 1
Displays information on dynamically learned and manually
configured multicast router interfaces.
Vista de pagina 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 89 90

Comentarios a estos manuales

Sin comentarios