Cisco SCE 2000 4/8xFE Manual de usuario descargar pdf (Pagina 12)

RELEASE SCOS 2.5.8

Release Notes for Cisco Service Control Operating System (SCOS) 2.5.10

OL-7085-08

Enhanced Link Recovery after Link Reflection

• Cisco Number CSCsb51681

SCOS 2.5.8 supports an enhanced link recovery protocol that ensures port recovery after link

reflection.

The link reflection function forces down the reciprocal port when the link fails. When the link

is restored, the reciprocal port that had been forced down is automatically restored, also. The

enhanced link recovery functionality tests the reciprocal port before restoring it. If the port is

down, the enhanced link recovery procedure is applied.

The enhanced link recovery mode is supported for all link failure reflection modes (normal, all

ports, and all ports linecard aware).

By default, this new mode is disabled. To enable the enhanced link recovery mode, use the

following CLI command:

configure

interface linecard 0

link port-enhance-recovery

To disable the enhanced link recovery mode, use the following CLI command:

configure

interface linecard 0

no link port-enhance-recovery

Package ID Variable Not Correctly Updated in Pull Mode

• Cisco Number CSCsc04812

In the following scenario, the subscriber package ID variable may not be correctly updated:

• Package ID is configured via anonymous subscriber templates.

• A new IP address spawns a new anonymous subscriber, which triggers a pull request to

the SM.

• The pull response returned by the SM includes the subscriber state, but no package ID.

• When Control receives a pull response, it updates the state and any variables that were

changed by the pull response. Variables that were not updated by the pull response

retain the default value. In this case, the package ID assigned by the anonymous

subscriber template will NOT be retained.

This issue was identified and fixed in SCOS 2.5.8.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sin comentarios

Cisco SCE 2000 4/8xFE Manual de usuario Pagina 12