Cisco WS-X6248-RJ-45 - Catalyst 6000 Expansion Module Manual de usuario descargar pdf (Pagina 10)

Cisco Systems, Inc.

Page 10 of 42

In Cisco IOS Software, the MSFC(1) does require that the Cisco IOS boot image (c6msfc-boot-mz) is stored in the

MSFC bootﬂash.

Note:

Flash card formats vary between CatOS and Cisco IOS Software thus ﬂash cards must be formatted when

switching between operating system models.

In Cisco IOS Software, the storage device on the active supervisor are as follows:

New images can be copied into the standby supervisor: ﬂash card, RP bootﬂash: or SP bootﬂash: from active

supervisor. The standby storage devices are:

The following is an example of the command you use to copy from active supervisor ﬂash card to standby

supervisor ﬂash:

Table 4 Cisco Hybrid OS Image Names

Image File Description

C6sup11 Bundled Layer 2–4 image for Supervisor 1, MSFC 1

C6sup12 Bundled Layer 2–4 image for Supervisor 1, MSFC 2

C6sup22 Bundled Layer 2–4 image for Supervisor 2, MSFC 2

slot0: Active Supervisor Linear Flash Card

disk0: Active Supervisor ATA Flash Card

sup-bootﬂash: Active Supervisor 16 MB or 32 MB onboard ﬂash

bootﬂash: Active MSFC 16 MB MSFC onboard ﬂash

slaveslot0: Standby Supervisor Flash Card

slavesup-bootﬂash: Standby Supervisor 16 MB or 32 MB onboard ﬂash

slavebootﬂash: Standby MSFC 16 MB onboard ﬂash

IOS# copy slot0:c6sup11-jsv-mz.121-5a.E1 slavesup-bootflash:

Destination filename [c6sup11-jsv-mz.121-5a.E1]?

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Sin comentarios

Cisco WS-X6248-RJ-45 - Catalyst 6000 Expansion Module Manual de usuario Pagina 10