Cisco Ex SERIES Manual de usuario descargar pdf (Pagina 49)

Juniper Networks/Cisco Systems Switch Interoperability Cookbook

! ! !

Juniper!configuration!

1. Assign an IP address of 192.18.0.10/24 to interface xe-5/3/1:

admin@EX9208> configure

admin@EX9208# set interfaces ge-0/0/22 unit 0 family inet address

192.18.0.10/24

2. Define an RPM probe and test for the Cisco switch at 192.18.0.1:

admin@EX9208# set services rpm probe myprobe test t1 probe-type icmp-ping-

timestamp

admin@EX9208# set services rpm probe myprobe test t1 target address

192.18.0.1

admin@EX9208# set services rpm probe myprobe test t1 probe-count 10

admin@EX9208# set services rpm probe myprobe test t1 probe-interval 1

admin@EX9208# set services rpm probe myprobe test t1 test-interval 15

admin@EX9208# set services rpm probe myprobe test t1 data-size 128

admin@EX9208# commit

Note that although only ICMP is used here, a single probe can encompass multiple tests

using multiple types of health checks.

Cisco!configuration!

1. Assign an IP address of 192.18.0.1/24 to the monitored interface (in this case

TenGigabitEthernet1/1/3):

Cat3850# configure terminal

Cat3850(config)# interface GigabitEthernet1/1/3

Cat3850(config-if)# no switchport

Cat3850(config-if)# ip address 192.18.0.1 255.255.255.0

Cat3850(config-if)# end

Cisco Nexus 7000 switches running the NX-OS operating system also require an explicit

“no shutdown” command to enable an interface.

No RPM-specific configuration is needed on the Cisco switch, or on any other device

monitored using RPM.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 82 83

Sin comentarios

Cisco Ex SERIES Manual de usuario Pagina 49