The Catalyst 3850 will recognize the Nexus 7010 via CDP:
Cat3850#show cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
D - Remote, C - CVTA, M - Two-port Mac Relay
Device ID Local Intrfce Holdtme Capability Platform Port ID
Nexus7010(TBM13093202)
Ten 1/1/4 138 R S C N7K-C7010 Eth
3/10
Nexus7010(TBM13093202)
Ten 1/1/3 138 R S C N7K-C7010 Eth
3/10
And the Nexus 7010 similarly will recognize the Catalyst 3850:
Nexus7010# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Device-ID Local Intrfce Hldtme Capability Platform Port ID
Cat3850.englab.juniper.net
Eth3/9 156 S I WS-C3850-48P Ten1/1/3
Cat3850.englab.juniper.net
Eth3/9 170 S I WS-C3850-48P Ten1/1/4
Note that in both cases, the Cisco switches correctly identified the hostname (“Device
ID”), model number (“Platform”) and interface (“Port ID”) of the remote Cisco device.
All this information is learned via CDP, which is forwarded without any additional
configuration needed on Juniper switches running Junos.
Generic&Routing&Encapsulation&(GRE)&
Objective!
To verify the ability of Juniper and Cisco switches to tunnel traffic over an IP backbone
using GRE.
Background!!
As described in IETF RFC 2784, GRE provides a method of encapsulating traffic into IP
packets for transmission across a routed network. On the receiving end, the traffic is
decapsulated and forwarded in its original form.
Although this configuration example uses IP-in-IP encapsulation, GRE can carry
virtually any protocol, including non-routable traffic such as raw Ethernet frames, across
a routed IP network.
Comentarios a estos manuales