Figure 17 illustrates the VRRP validation test bed. In this example, both the Juniper and
Cisco devices advertise the virtual IP address of 192.18.38.254. On both the Juniper and
Cisco devices, the IP address is assigned to the physical interface rather than a VLAN
interface. However, VRRP would work equally well with IP addresses assigned to VLAN
interfaces.
!"#$%&'(J)'F77,'9.3":.0"2;'02-232#4'
Juniper!commands!
Configure an IP address on interface xe-5/0/5, and also define vrrp-group 1 on that
interface:
admin@EX9208> config
admin@EX9208# set interfaces xe-5/0/5 description "VRRP link to Nexus 7010
e3/10"
admin@EX9208# set interfaces xe-5/0/5 unit 0 family inet address 192.18.38.1/24
vrrp-group 1 virtual-address 192.18.38.254
admin@EX9208# set interfaces xe-5/0/5 unit 0 family inet address 192.18.38.1/24
vrrp-group 1 priority 254
admin@EX9208# set interfaces xe-5/0/5 unit 0 family inet address 192.18.38.1/24
vrrp-group 1 preempt
Comentarios a estos manuales