
Overview 1-23
Management Console
Management Console
The management console is a menu-driven interface for configuring and monitoring the
switch. If your management station is directly connected to the switch console port, you
can use the management console even when the network is down because your direct
connection to the console bypasses the network and communicates directly with the switch.
For information about using the management console, see Chapter 4, “Configuring and
Monitoring from the Management Console.”
Table 1-11 lists the configuration settings, including default values, available from the
management console.
Table 1-11 Features, Default Settings, and Management Console Menus
Feature
Default
Setting Console Menu
Management
IP address, subnet mask, and default gateway
of the switch
0.0.0.0 IP Configuration Menu
Cisco Discovery Protocol (CDP) Enabled CDP Configuration/Status Menu
Performance Tuning
Switching mode FragmentFree
(cut-through)
System Configuration Menu
Enhanced congestion control on 10BaseT ports Disabled System Configuration Menu
Enhanced congestion control on 100BaseT ports Disabled Port Configuration Menu (100BaseT Ports)
Duplex mode on 10BaseT ports Half duplex Port Configuration Menu (10BaseT Ports)
Half-duplex back pressure on 10BaseT ports Disabled System Configuration Menu
Duplex mode on 100BaseFX port Half duplex Port Configuration Menu (100BaseT Ports)
Duplex mode on 100BaseTX ports Autonegotiate Port Configuration Menu (100BaseT Ports)
Flooding/Traffic Control
Broadcast storm control Disabled System Configuration Menu
Network port None System Configuration Menu
Cisco Group Management Protocol (CGMP) Enabled Cisco Group Management Protocol (CGMP)
Configuration Menu
Overlapping bridge groups Disabled Bridge Group Configuration Menu
Store-and-forward on multicast Disabled System Configuration Menu
Comentarios a estos manuales