Cisco WS-C1924-EN-DC - 100Mbps Ethernet Switch Manual de usuario Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 38
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
Front-Panel Description
Catalyst 1900 Series Installation and Configuration Guide
1-6
The model with two fiber-optic ports (A and B) use MT-RJ connectors and have a
fiber-optic wavelength of 1300 nanometers. To connect each fiber-optic port on the switch
to an SC or ST port on a 100BaseFX-compatible device on your network, you must use the
appropriate MT-RJ fiber-optic patch cable. You can order MT-RJ patch cables from your
cable vendor, or you can order these cables from Cisco:
CAB-MTRJ-SC-MM-1M (1-meter, MT-RJ-to-SC multimode cable)
CAB-MTRJ-SC-MM-3M (3-meter, MT-RJ-to-SC multimode cable)
CAB-MTRJ-SC-MM-5M (5-meter, MT-RJ-to-SC multimode cable)
CAB-MTRJ-ST-MM-1M (1-meter, MT-RJ-to-ST multimode cable)
CAB-MTRJ-ST-MM-3M (3-meter, MT-RJ-to-ST multimode cable)
CAB-MTRJ-ST-MM-5M (5-meter, MT-RJ-to-ST multimode cable)
For connection information, see the “Connecting to the Switched 100-Mbps Fiber-Optic
Ports” section on page 2-29.
LEDs and Modes
You can use the LEDs to monitor switch activity and performance by using the Mode button
to select the modes in which the port LEDs operate (Figure 1-3).
Figure 1-3 LEDs and Mode Button
Port LEDs
Port mode LEDs
Redundant power
system LED
H9261
1x 2x 3x 4x
Mode
button
System status LED
26604
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Comentarios a estos manuales

Sin comentarios